/usr/share/automake-1.16/am
Edit: /usr/share/automake-1.16/am/subdirs.am (2868B)
## automake - create Makefile.in from Makefile.am
## Copyright (C) 1994-2018 Free Software Foundation, Inc.
## This program is free software; you can redistribute it and/or modify
## it under the terms of the GNU General Public License as published by
## the Free Software Foundation; either version 2, or (at your option)
## any later version.
## This program is distributed in the hope that it will be useful,
## but WITHOUT ANY WARRANTY; without even the implied warranty of
## MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
## GNU General Public License for more details.
## You should have received a copy of the GNU General Public License
## along with this program. If not, see
.
RECURSIVE_TARGETS += all-recursive check-recursive installcheck-recursive
RECURSIVE_CLEAN_TARGETS = mostlyclean-recursive clean-recursive \
distclean-recursive maintainer-clean-recursive
am__recursive_targets = \
$(RECURSIVE_TARGETS) \
$(RECURSIVE_CLEAN_TARGETS) \
$(am__extra_recursive_targets)
## All documented targets which invoke 'make' recursively, or depend
## on targets that do so. GNUmakefile from gnulib depends on this.
AM_RECURSIVE_TARGETS += $(am__recursive_targets:-recursive=)
.PHONY .MAKE: $(am__recursive_targets)
# This directory's subdirectories are mostly independent; you can cd
# into them and run 'make' without going through this Makefile.
# To change the values of 'make' variables: instead of editing Makefiles,
# (1) if the variable is set in 'config.status', edit 'config.status'
# (which will cause the Makefiles to be regenerated when you run 'make');
# (2) otherwise, pass the desired values on the 'make' command line.
$(am__recursive_targets):
## Using $failcom allows "-k" to keep its natural meaning when running a
## recursive rule.
@fail=; \
if $(am__make_keepgoing); then \
failcom='fail=yes'; \
else \
failcom='exit 1'; \
fi; \
dot_seen=no; \
target=`echo $@ | sed s/-recursive//`; \
## For distclean and maintainer-clean we make sure to use the full
## list of subdirectories. We do this so that 'configure; make
## distclean' really is a no-op, even if SUBDIRS is conditional.
case "$@" in \
distclean-* | maintainer-clean-*) list='$(DIST_SUBDIRS)' ;; \
*) list='$(SUBDIRS)' ;; \
esac; \
for subdir in $$list; do \
echo "Making $$target in $$subdir"; \
if test "$$subdir" = "."; then \
dot_seen=yes; \
local_target="$$target-am"; \
else \
local_target="$$target"; \
fi; \
($(am__cd) $$subdir && $(MAKE) $(AM_MAKEFLAGS) $$local_target) \
|| eval $$failcom; \
done; \
if test "$$dot_seen" = "no"; then \
$(MAKE) $(AM_MAKEFLAGS) "$$target-am" || exit 1; \
fi; test -z "$$fail"
mostlyclean: mostlyclean-recursive
clean: clean-recursive
distclean: distclean-recursive
maintainer-clean: maintainer-clean-recursive